ONION TOPPER Type A 1

ONION TOPPER Type A 1

Specifications Value
Total length 1820 mm
Total width 1900 mm
Total height 2000
Infeed height, space 200 mm waste belt min.1830 mm
Out feed height lower about 300 mm
Width of the sieves 920 mm
Opening of the sieves standard 25 mm
Vibration motor on the sieves 0,37 kW
Motor knife 3 kW
Protection of dust and noise enclosed hoods
Waste belt 2500 mm x 600 mm – 0,37 kW
Options
  • Pre-grader

The pre-grader of the A1 onion topper will cause the undersize produce, and small waste, to fall through. This makes sure the undersize onions do not enter the machine, which creates dust and causes you to have to clean the machine more often

  • Extra sieve
  • Frequency inverter  knife motor
  • Extra set of knifes for one propellor
  • Frequency inverter on the sieve motor

In some cases, it is needed that the sieves of the machine do not shake at full speed. This might occur when the produce is very delicate. In most cases however it is best to have the motor run at full speed.

  • Machine on wheels

In some cases it is needed to be able to transport the onion topper. Allround VP is able to fit the machine with wheels.

Description:

Onion toppers are designed to top the ‘tail’ of onions. This is done by rotating knifes under vibrating sieves. The vibrating sieves causes the ‘tail’ of the onions to fall through the sieves, and is then cut off by the knife. The sieves of the machines are very easy to change because of the ‘quick lock’ system. The Allround VP onion toppers are designed to be extremely produce friendly, and safe to use. Topping waste is caught in a 600 mm funnel. Knives and propeller must be cleaned daily

Top